JL Audio Fathom f110 - Manual (Page 22)

| Fathom f110 Page 22
SYSTEM CONNECTION DIAGRAM 1:
One Fathom to
Home Theater Receiver or
Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer output. When
connecting a mono subwoofer output
to your Fathom, you will only use the
Fathom’s “Left or Mono” input.
Two connection types are available
for connecting the Fathom to your home
theater system: balanced (XLR or 1/4-
inch TRS connector) and unbalanced
(RCA-type connector). Balanced
connections provide superior noise
rejection and ensure proper grounding
between components. If your receiver or
processor has balanced outputs, we highly
recommend that you use them.
In the connection diagram at left ,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
es with part 15 of the FCC rules. Operation is
owing two conditions: (1) this device may not
rference, and (2) this device must accept any
ved, including interference that may cause
n.
SUB REAR
REAR CENTER
FRONT
FRONT
R
L
PRE OUT
PROCESSOR (BALANCED OUTPUTS) RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)
OR
FATHOM REAR CONTROLS (MASTER)
OUTPUTS
WARNING! TURN OFF THE FATHOM AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
WARNING