Jonsered GT2125L - Manual (Page 12)

12
– English
ASSEMBLY
Assembling the loop handlebar
(GT2125L) Assembly of the trimmer head
It is extremely important
that the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
!
WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter
“Technical
data”. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
Assembling the loop handlebar
(GR2126L)
• Position the handle on
the shaft. Note that the
handle must be mounted
below the arrow on the
shaft.
• Fit the bolt, securing plate
and wing nut as shown in
the diagram.
• Tighten the wing nut.
• Clip the loop handle onto
the shaft. Note that the
loop handle must be
fitted between the arrows
on the shaft.
• Slide the spacer into the
slot in the loop handle.
• Fit the nut, washer and
bolt.
• Now adjust the trimmer
to give a comfortable
working position. Tighten
the bolt/knob.