JVC GR-DVL315 - Manual (Page 23)

EN
23
SNAP MODE –
FUL L
MUL T I – 4
MUL T I – 9
P I N–UP
FRAME
FOR RECORDING
Snapshot
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
Set the Power Switch to “ ” while pressing down the
Lock Button located on the switch.
2
Press the MENU/BRIGHT wheel in. The Menu Screen
appears.
3
Rotate the MENU/BRIGHT wheel to select “
CAMERA”. Press it and the CAMERA Menu appears.
4
Rotate the MENU/BRIGHT wheel to select “SNAP
MODE”, then press it.
5
Rotate the MENU/BRIGHT wheel to select the desired
Snapshot mode, then press it.
Rotate the MENU/BRIGHT wheel to select “1RETURN”
and press it twice. The Menu Screen closes.
SNAPSHOT RECORDING
1
Press SNAPSHOT.
If you press during Record-Standby . . .
..... “PHOTO” appears and a still image will be recorded
for approx. 6 seconds, then the camcorder re-enters
the Record-Standby mode.
If you press during Recording . . .
..... “PHOTO” appears and a still image will be recorded
for approx. 6 seconds, then the normal recording
resumes.
• Regardless of the Power Switch position (“ ” or “ ”),
Snapshot recording takes place using the selected
Snapshot mode.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to serial
photography. (Interval between still images: approx. 1 second)
NOTES:
● To remove the shutter sound,
੬
“BEEP” on pg. 31, 33.
● Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom or Night-Alive (
੬
pg. 24).
● If Snapshot recording is not possible, “PHOTO” blinks when
SNAPSHOT is pressed.
● If Program AE with special effects (
੬
pg. 24) is engaged,
certain modes of Program AE with special effects are disabled
during Snapshot recording. In such a case, the icon blinks.
● If SNAPSHOT is pressed when “DIS” is set to “ON”
(
੬
pg. 32), the Stabilizer will be disabled.
● During Snapshot recording, the image displayed in the
viewfinder may be partially missing. However, there is no
effect in the recorded image.
● When a cable is connected to the AV connector, the shutter
sound is not heard from the speaker, however it is recorded
onto the tape.
● will appear while the snapshot is being taken.
● During playback as well, all Snapshot modes are available.
The shutter sound is not heard.
Power Switch
SNAPSHOT Button
Lock Button
Display
Menu Screen
FULL
Snapshot mode
with no frame*
PIN-UP
Pin-Up mode* FRAME
Snapshot mode with
frame*
MULTI-4
Multi-Analyzer 4
* There is the sound effect of a shutter closing.
MULTI-9
Multi-Analyzer 9