John Lewis SBSKITB - Manual (Page 7)

7
C D
40
mm
A B
• Carefully place the unit on the floor, following the instructions on the packaging to make sure the unit is
facing upwards.
• Open the bottom part of packaging and remove the corner protection.
• «A» Screw the M8 nuts (bag «4») on the respective front feet.
• «B» Screw the front feet on the bracket of the unit using the dimension indicated in fig. «C».
• «C» Position the rear feet on the compressor support plate.
• «D» Insert the pin, using a hammer, so that it does not protrude outside the foot.
• Carefully reposition the appliance in the upright position and remove completely the packaging.
• Operation to be carried out on both units.