How to adjust volume on the controller, How to mute the headset, How to answer a call from your pc softphone – Jabra LINK 280 User Manual

Page 3: How to connect controller to headset, How to connect controller to pc

Advertising
background image

4

5

how To adJusT voLume on The conTroLLer

Use the wheel at the center of the

controller to adjust the volume.

Turn clockwise to turn up and

counterclockwise to turn down. You will

hear a soft click in the headset each time

you adjust the volume.
When you reach maximum volume, the

headset will beep twice as a warning.

We recommend that you do not use the

headset at full volume.

how To muTe The headseT

It is possible to mute the microphone on the headset so that no sound/voice will be transmitted from the

headset to the PC.
By tapping the mute button the microphone is now muted. The lights will go from a solid green to pulsating red.

It will continue to pulsate red while muted.
To un-mute: tap

the mute button

again and the

light will go from

pulsating red to

solid green.

Green when not muted

Red when muted

how To answer a caLL from your Pc sofTPhone

When a softphone call arrives, you will hear a ring tone in the headset.

If you are using a Jabra-supported softphone*, then answer by tapping on the hook-switch button on the USB

controller; tap again to hang up when you are done. Softphone control requires that you install Jabra PC Suite

(described later in this manual).

For other softphones, use the native interface on your computer to answer and hang up.
When you are using a

supported softphone,

the controller lights

work as indicated to

the right.
You also have the

option of rejecting

an incoming call by

pressing and holding

the assigned Soft

button. The incoming

call will then be

rejected.

Solid green while idle

Flashing green/

blue on incoming

call

Red while on a call

how To connecT conTroLLer To headseT

Plug the QD to the QD of any Jabra GN corded headset.

how To connecT conTroLLer To Pc

Plug the USB plug into a free USB port on your PC. Once connected, the active mute and hookswitch buttons will

be illuminated.
The first time connected, your PC displays a small pop-up message in the task bar to indicate that a new device

has been found. You are now ready to use the controller.

* See www.jabra.com for an up-to-date list of supported softphones.

Advertising