JOBO Photo Display Mirage L - Manual (Page 5)

��������������������������������������
Seite 4 von 7
You will see the following screen if you insert the memory card correctly. Make sure you have at least one picture
stored on the memory card. The frame will not function properly without a stored picture.
Please select the memory card, press the button from the unit or remote control to enter the following screen.
2.2. Viewing Picture
1. You can use either the remote control or the on-board buttons to control the Mirage L.
2. Remove the plastic battery insulator (if any) on the bottom of the remote control and make sure the remote
control has a battery installed. See “Installing and replacing battery” section if you need a new battery.
3. Use the remote control to highlight and select the Photo folder (Use the direction keys Right, Left on the
remote control to navigate and press Enter to select).
4. Highlight a picture and press Enter to view the picture.
5. Press “PLAY” button to view the picture sequential.
2.3. Installing and Replacing the Remote Control Battery
1. Place the Remote Control with the control buttons facing downward.
2. While pressing down on the ridged area of the battery cover pull the tray out.
3. Place a “CR2025” lithium battery on the tray with the positive “+” end facing toward you.
4. Close the tray.
+