JVC GET0735-001A User Manual
Page 15
15
ENGLISH
Menu item
Selectable setting, [Initial: Underlined]
AUDIO
SUB.W *
6
ON : Turns on the subwoofer output. / OFF : Cancels.
SUB.W LPF *
7
LOW 55Hz / LOW 85Hz / LOW 120Hz : Frequencies lower than
55 Hz/85 Hz/120 Hz are sent to the subwoofer.
SUB.W LEVEL *
7
00 — 08 [ 04 ] : Adjusts the subwoofer output level.
HPF
ON : Activates the High Pass Filter. Low frequency signals are cut off from the front/rear
speakers.
/ OFF : Deactivates (all signals are sent to the front/rear speakers).
BEEP
ON / OFF : Activates or deactivates the keypress tone.
TEL MUTING *
8
ON : Mutes the sounds while using the cellular phone (not connected through
KS-BTA100). /
OFF : Cancels.
AMP GAIN *
9
LOW POWER : VOLUME 00 – VOLUME 30 (Selects if the maximum power
of each speaker is less than 50 W to prevent damaging the speakers.) /
HIGH POWER : VOLUME 00 – VOLUME 50
TUNER
SSM
Displayed only when the source is “FM.” For settings, see page 7.
AREA
US : When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz.
/ EU : When using in any other areas. AM/FM intervals are set to
9 kHz/50 kHz.
/ SA : When using in South American countries where FM interval is
50 kHz. AM interval is set to 10 kHz.
MONO
Displayed only when the source is “FM.” For settings, see page 7.
IF BAND
AUTO : Increases the tuner selectivity to reduce interference noises between adjacent
stations. (Stereo effect may be lost.)
/ WIDE : Subject to interference noises from
adjacent stations, but sound quality will not be degraded and the stereo effect will
remain.
IPOD SWITCH *
10
HEAD MODE : Controls iPod playback through the unit. / IPOD MODE : Controls
iPod playback through the iPod/iPhone.
/ EXT MODE : The sound of any functions
(musics, games, applications, etc.) running on the connected iPod/iPhone is emitted
through the speakers connected to this unit. The display always show “EXT MODE.”
SRC SELECT
AM *
11
ON / OFF : Enable or disable “AM” in source selection.
F-AUX *
11
ON / OFF : Enable or disable “F-AUX” in source selection.
R-AUX *
11
ON / OFF : Enable or disable “R-AUX” in source selection. / BT ADAPTER : Selects if
the rear auxiliary input jack is connected to the Bluetooth adapter, KS-BTA100. (page 9)
The source name changed to “BT AUDIO.”
*
6
For KD-R628/KD-A625.
*
7
For KD-R620: Displayed only when <L/O MODE> is set to <SUB.W>.
*
8
This setting does not work if <BT ADAPTER> is selected for <R-AUX> of the <SRC SELECT>.
*
9
The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the volume
level set higher than “VOLUME 30.”
*
10
Displayed only when “USB-IPOD” is selected as the source.
*
11
Displayed only when any source other than “AM/F-AUX/R-AUX/BT AUDIO” is selected separately.
EN02-19_KD-R628[J]f.indd 15
EN02-19_KD-R628[J]f.indd 15
11/2/10 10:36:10 AM
11/2/10 10:36:10 AM