JVC KD-APD58 - Manual (Page 14)

14
ENGLISH
Indications Item
( : Initial) Setting, [reference page]
SCROLL * 2
Scroll
• ONCE
• AUTO
• OFF : Scrolls the track information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
• Pressing D DISP for more than one second can scroll the display
regardless of the setting.
L/O MODE
Line output mode • REAR
• WOOFER
: Select if both the LINE OUT terminals are used for connecting the
speakers (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting a
subwoofer (through an external amplifier).
WOOFER * 3
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH : Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
AUX ADJ
Auxiliary input level
adjustment A.ADJ 00
— A.ADJ 05 : Adjust the auxiliary input level to avoid the sudden increase of the
output level when changing the source from external component
connected to the AUX input jack on the control panel.
TAG DISP
Tag display • TAG ON
• TAG OFF : Shows the Tag information while playing MP3/WMA tracks, [9].
: Cancels.
AMP GAIN
Amplifier gain
control • LOW PWR
• HIGH PWR
: VOL 00 – VOL 30 (Select this if the maximum power of the speaker is
less than 50 W to prevent damaging the speaker.)
: VOL 00 – VOL 50
AREA
Tuner channel
interval • AREA US
• AREA EU
• AREA SA
: When using in North/Central/South America. AM/FM intervals are set
to 10 kHz/200 kHz.
: When using in any other areas except North/Central/South America.
AM/FM intervals are set to 9 kHz/50 kHz (100 kHz during auto search).
: When using in South American countries. AM/FM intervals are set to
10 kHz/100 kHz.
IF BAND
Intermediate
frequency band • AUTO
• WIDE
: Increases the tuner selectivity to reduce interference noises between
close stations. (Stereo effect may be lost.)
: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
* 2 Some characters or symbols will not be shown correctly (or will be blanked) on the display.
* 3 Displayed only when “L/O MODE” is set to “WOOFER.”
EN12-19_KD-APD58_50[J]f.indd 14 EN12-19_KD-APD58_50[J]f.indd 14 11/7/06 12:53:35 PM 11/7/06 12:53:35 PM