JL Audio XR650-CX - Manual

Set "Filter Freq."
to "80" (24 clicks) Adjust "Boost" to
"+3" initially
Adjust "Input Sens." to
achieve desired output
level from subwoofer
Connect to
CS112-W3 Connect to head unit
line level output Connect to input
of 300/2 Amplifier
Set "Filter Freq." to
80 Hz (15 clicks)
Adjust "Input Sens."
to achieve desired output
level from front speakers
Left Speaker output to both left speakers (8
Ω
resistor inline with rear)
Right Speaker output to both right speakers (8
Ω
resistor inline with rear)
Connect to 250/1
preamp outputs This section is not
used in this application
= POSITION
Recommended initial amplifier settings for this system...
8 Ω 25w
Resistor
8 Ω 25w
Resistor
XR650-CX
(Left Rear)
XR650-CX
(Right Rear)
XR650-CS
(Left Front)
250/1
CS112-W3
(Subwoofer)
XR650-CS
(Right Front)
Aftermarket Head Unit
300/2
Note: These settings are intended as a “baseline” for tuning this system. Depending on the vehicle and the customer’s
tastes, some variation in the crossover and bass control settings may be necessary for optimum performance.
SYSTEM 8:
Audiophile Single-
Subwoofer System
This is a perfect setup for the
customer who wants the highest
levels of sound quality but is not
interested in huge bass.
The single 12W3 in the
CS112-W3 provides strong output
and excellent bass quality without
taking up a ton of trunk space. It's
driven by a 250/1 monoblock.
The four XR systems (XR650-CS
in the front, XR650-CX in the rear)
are cleanly driven by the 300/2.
This system is shown connected
to a single pair of line level outputs
at the head unit. In this configuration,
front-to-rear fading is not possible
and subwoofer level must be
carefully preset.
RCA Cable (pair)
Speaker Wire
Remote Lead