Assembling the handlebar and throttle, Transport position, handlebar, Assembling the cutting equipment – Jonsered GR41/50 User Manual
Page 13: Assembly
English
– 13
ASSEMBLY
Assembling the handlebar and
throttle
•
Unscrew the knob from the handlebar mounting.
•
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
•
Fit the right handle to the handlebar using the screw,
washer, sleeve and nut as shown. Tighten.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness.
Tighten the knob.
Transport position, handlebar
•
The handlebar can easily be turned to fit along the shaft
for easier transportation and storage.
•
Loosen the knob. Turn the handlebar clockwise so that the
throttle handle rests against the engine.
•
Now twist the handlebar around the shaft. Tighten the
knob.
•
Fit the transport guard to the cutting attachment.
Assembling the cutting equipment
Fitting a blade guard, grass blade
and grass cutter
•
The blade guard (A) is fitted using 4 screws (L) and the
support plate (M) as shown.
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Place the blade (D) on the output shaft.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
M
E
N
F
D
B
C
A
L