Jaguar VOICE ACTIVATION X-TYPE 2001.5 - Manual (Page 34)

Voice activation 31
Voice training (continued)
6. You will be prompted to read from the list of phrases,
see Training command list on page 33, one phrase at a
time. After each prompt, press and release the voice button,
wait for the end of the beep then say the phrase. If you make
a mistake, continue anyway. Speak in a natural voice without
pausing between words.
7. When the system has heard enough phrases (between 25 and
40) it will create a voice memory. The system will ask for a
nametag to be stored with the voice memory. Press and
release the voice button, wait for the end of the beep and say
your choice of nametag.
8. After you have given the nametag, the system processes the
commands and stores the voice memory in memory A or B.
Please wait until the voice system indicates that training has
been completed (do not turn off the ignition during this time).
Training is complete when the system gives verbal feedback
and shows VOICE READY in the instrument cluster display.
9. The phone system can now be turned back on using the
appropriate control buttons or by giving PHONE ON voice
command.
Vehicles not fitted with navigation system:
1. First, select which voice memory to train. To check which
memories are already in use, use the VOICE DIRECTORY
command. This will list the memories used and, if stored with
a nametag, the names of the users stored. If no memories are
in use, either memory can be used. If both memories are in
use and you wish to overwrite one of the memories select the
memory you wish to overwrite.
2. Position the vehicle, with the sunroof and windows closed, in
a reasonably quiet outdoor location.
3. Sit in the driving seat with the engine running, the handbrake
on and the transmission in Park or Neutral.
4. Press and hold the MODE button on the radio (adjacent to
the volume control) for more that two seconds. The radio
display will then show "TA VOLUME". Press the MODE button
twice more until "VOICETRAIN A" is displayed. To select
"VOICETRAIN B" press the MODE button again.
5. With "VOICETRAIN A" or "VOICETRAIN B" displayed on the
radio press the seek up control to start voice training. Once
you have selected which memory to use the system gives
verbal instructions about the training procedure.
6. After the instructions press and release the voice button to
start training. If you have chosen to overwrite an existing
memory by mistake and would like to cancel press and hold
the voice button for 5 seconds.