Jensen Tools JCD2006 - Manual (Page 7)

JCD2006
7
TUNER OPERATION
Select a Band
Press the BAND button (9) to change between three FM bands and two AM bands. Each band
stores up to six preset stations.
Tuning
Auto Seek Tuning
Press the TUNE >>| or |<< button (7) for less than three seconds to move to the next station
automatically.
Manual Tuning
Press the TUNE >>| or |<< button (7) for more than three seconds to enter manual tuning
mode. Press the TUNE buttons to change the radio frequency number up or down one step.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button (13-18) for three seconds.
The unit will beep and the preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (13-18) to select the corresponding stored
station.
Automatically Store / Preset Scan (AS.PS)
Automatically Store
Select a band (if needed). Press the AS.PS button (3) for more than three seconds to
automatically select the six strongest stations and store them in the current band. The new
stations replace any stations already stored in that band.
Preset Scan
Select a band (if needed). Press the AS.PS button (3) to scan stations stored in the current
band. The unit will pause for five seconds at each preset station. Press AS.PS again to stop
scanning when the desired station is reached.
CD PLAYER / RECEIVER
JCD2006 40 WATTS X 4 AS PS
RDM CH
CD-I N
RPT INT
13 14 15 16 17 18 19