Jwin JX-CD900 - Manual (Page 5)

IN-CAR CONNECTION
In-car use (connections supplied or optionally available)
Only use the car voltage converter (4.5V, DC, positive pole to the center pin) and the car
adapter cassette. Any other product may damage the set.
1
Put the CD player on a horizontal, vibration-free and stable surface. Make sure it is a
safe place, where the player is not a danger or obstacle to the driver and
passengers.
2
Connect the DC plug of the voltage converter to the 4.5V DC jack of the CD player
(only for a 12V car battery, negative grounding).
3
Insert the voltage converter into the cigarette lighter jack. If necessary, clean the
cigarette lighter jack to obtain a good el ectrical contact.
4
Turn down the volume and connect the adapter cassette plug to the LINE OUT of the
CD player.
5
Carefully insert the adapter cassette into the car radio’s cassette compartment.
6
Make sure the cord does not hinder your driving.
7
Start the CD player, set VOL to the lower position and adjust the sound with the car
radio controls.
l Always remove the voltage converter from the cigarette lighter jack when the CD
player is not in use.
Notes:
- Avoid excessive heat from the car heating or from direct sunlight (e.g. in
a parked car in the summer).
- If your car radio has a LINE IN jack, use the LINE IN jack for the car
radio connection instead of the adapter cassette. Connect the signal lead
to this LINE IN jack and the LINE OUT jack of the CD player.
CD PLAY
Playing a CD
This CD player can play all kinds of Audio Discs and MP3 CD- ROM such as CD
Recordables and CD Rewritables. Do not try to play a Cdi, CDV or computer CD or DVD.
1
Push the OPEN slider and the lid opens.
The “ Door Open” indicator will appear in LCD.
2 Insert an audio CD, printed side up, by pressing
gently on the CD center so that it fits onto the hub.
Close the lid by pressing it down on the left side.
3
Press PLAY/PAUSE button for approximately 1
second to switch t he set on and start playback.
The current track number and the elapsed playing
time are displayed. It will take approx. 5 seconds
for a CD to begin playback.
l You can interrupt playback by pressing
PLAY/PAUSE button.
The time where playback was interrupted is
flashing.
l Continue playback by pressing
PLAY/PAUSE button again.
4
Press STOP button to stop playback.
The total number of tracks and the total playing
time of the CD are displayed.
5 Press STOP button again to switch off the set.
6
To remove the CD, hold it by its edge and press
the hub gently while lifting the CD.
•
When the unit is turned on, the “ESP” function is
automatically turned on, and shown on display
“ESP”. If ESP function is not required, please press
ESP button to turn it off.
To DC IN Jack
To
6 7
Ca
s se
tte
De
ck
Car Cassette