JVC HR-J435EK - Manual (Page 17)

17
1 2
4 5
3
6
8
0
7 9
1
3
2
6
q
FF
REW
C.RESET
COUNTER RESET
C. MEMORY
ACTIVATE SCENE FINDER
1
Press SCENE FINDER. The recorder starts forward high-
speed search for 5 seconds and then fast-forwards 10
minutes on the counter. This cycle is repeated until the
end of the tape is reached.
● To start Scene Finder in the reverse direction, press
SCENE FINDER and then turn the SHUTTLE ring to
the left (or press the remote’s REW button) within 2
seconds. This cycle is repeated until the beginning of
the tape.
● During Scene Finder, the following indications appear
on the display panel:
STOP SCENE FINDER
2
Press STOP.
NOTES:
● During Scene Finder high-speed search, you can also hear the
tape sound. During fast forward or rewind, you hear the
current TV sound instead.
● Scene Finder does not function during Index Search.
This function helps you check contents of unlabeled recorded
tapes at the touch of a single button.
NOTE:
Scene Finder cannot be used when the recorder is in the Record
mode.
Scene Finder
10 minutes
on counter
FF REW FF REW FF REW
Search Search Search
5 seconds 10 minutes
on counter
5 seconds 5 seconds
SHUTTLE
SCENE FINDER
STOP
Counter Memory
Returns to the counter reading of “0:00:00” to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press COUNTER RESET during playback at a point you
wish to locate later. The counter reads “0:00:00”. Then
press C.MEMORY, and “M” appears in front of the
counter digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
● The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
● To cancel Counter Memory, press C.MEMORY again.
STOP