JVC XL-PG31 - Manual (Page 26)

26
Using the Unit
with Optional
Accessories
Using the unit with an audio system
Using a stereo connection cable (not included), you can
listen to CDs through your audio system.
• Connect the cable to the amplifier after turning off its
power.
• Do not connect the cable to the PHONO jacks on the
amplifier.
• Obtain the optional connecting cable if the amplifier
comes with mini-phone jacks.
• Adjust the volume level on the amplifier.
a LINE OUT jack,
b Stereo connection cable (not included),
c Amplifier, d Left side panel of the unit, e (White),
f (Red)
To use player with an optical cable, use the AC adaptor
and check that the A.S.P.(Anti-Shock Protection)function
is off.
Note:
To obtain original sound, set HBS to “OFF”.
Using the unit with a car audio
system stereo
XL-PV310 comes with the car adaptor and car audio
cassette adaptor.
• Car adaptor (CA-R456)
• Car audio cassette adaptor (CA-RC6)
To connect to a car audio system:
Connect the car audio cassette adaptor to the
unit’s headphones jack. (When doing this,
keep the unit’s VOLUME control at a setting
minimum position.)
If there is an Aux jack in the car audio system, connect
the OUT jack of the CD player with the Aux jack using
a 3.5 mm diameter stereo mini-plug signal cord
(optional).
Depending on the automobile used, noise may occur,
and in that case, it is recommended that a KS-U32
noise filter (optional) be used.
Note:
It may not be possible to use the unit with some types
of car stereo owing to restrictions imposed by the
construction of the car audio cassette adaptor.
For further details, refer to the instructions of the part
concerned.
A
L
CD/AUX
R
a
b d
e
f
c