Edit to or from another recorder, Pg. 53, L-1)) – JVC SR MV45U User Manual

Page 53

Advertising
background image

Masterpage:Right+

EN

53

Filename [SR-MV45_55U_10Editing.fm]

Page 53

January 10, 2007 1:18 pm

EDITING

You can use your unit as the source player or as the recording
deck.
NOTE:
When using another recorder as the recording deck, refer to its
instruction manual.

1

Make connections.

When using this unit as the recording deck
A If the another recorder has no S-VIDEO connector, connect the
unit’s [AUDIO/VIDEO INPUT] connectors to the audio/video output
connectors on another recorder.
B If the another recorder has S-VIDEO connector, connect the
[AUDIO INPUT] and [S-VIDEO INPUT] connectors to the audio
and S-video output connectors on another recorder.

● If connecting a unit with an S-VIDEO connector, it is recommended to

use the supplied S-Video cable to minimize picture degradation while
editing.

2

Press VCR/DVD repeatedly to select the recording deck.

3

Press INPUT SELECT +/– on the unit or INPUT +/– or AUX on

the remote control to select “L-1” when using this unit as the
recording deck.

● Set “REAR AUX L-1” to “VIDEO” for the [VIDEO INPUT] connector,

or “S-VIDEO” for the [S-VIDEO INPUT] connector, depending on the
connector being used. (

੬ pg. 59) This setting is also applied to the

VCR deck.

4

For VCR deck only

Set “PICTURE CONTROL” to the appropriate mode. (

੬ pg. 61)

5

Press REC MODE repeatedly to set the recording mode.

(

੬ pg. 36)

6

Engage the Play mode of the source player.

For VCR deck only
Press 7 and 9 simultaneously to set to record pause mode.

7

Engage the Record mode of the recording deck.

For VCR deck only
After about 10 seconds, press 4 to start recording.

8

Stop recording on the recording deck, then stop playback on the

source player.

NOTES:

● All necessary cables can be obtained from your dealer.

● When you use this unit as the source player for editing, be sure to set

“SUPERIMPOSE” to “OFF” before starting. (

੬ pg. 59)

● When you select “EDIT” to dub tapes in step 4, be sure to select

“AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”)
after you finish dubbing the tapes.

Edit To Or From Another Recorder

Player

Your unit

Another recorder

Recorder

TV receiver

Slide the TV/CABLE/DBS/DVD switch to DVD.

SR-MV45_55US.book Page 53 Wednesday, January 10, 2007 1:18 PM

Advertising
This manual is related to the following products: