JAI CV-M40 - Manual (Page 7)

CV-M40
7
5-2. 6 pin connector (TRIGGER connector)
HR10A-7R-6P (Hirose) male
* Note : To change the signal output on pin no. 5 and 6, it is necessary to make jumper setting.
See “7-2. Jumpers on board” for more informations.
When trigger signal is input at #5 of 6 pin multi connector, do not input/output HD signal at #6 of 12 pin multi
connector, as it causes a failure in external trigger mode.
1.
Do not input HD or VD signal at pin no.5, when the camera is set at Continuous mode. 2.
Pin no.
HD/VD input or
output
Ext.
trigger/readout
TXD output
RXD input
Ground
Ground
**See note 2. Ext. trigger input
1
2
3
4
5*
6*
WEN output
Pin no. Factory pre-set Others
5 Trigger input NC
6 WEN output NC
CAUTION