JVC HR-XVC33UM - Manual (Page 17)

Masterpage:Right-No-Heading
EN
17
Filename [XVC33UM_06Index.fm]
Page 17 4 August 2003 6:42 pm
F
Start Auto Channel Set.
Press MENU.
● Receivable channels in your area
are automatically assigned to the
CH +/– buttons, and non-
receivable channels are skipped.
● When Auto Channel Set is
completed, “SCAN
COMPLETED” will appear on the
TV screen. If “SCAN
COMPLETED –NO SIGNAL–” is
displayed on the TV screen, make sure that the aerial cable is
connected to the unit properly and press OK on the Remote.
The unit will try Auto Channel Set again.
NOTE:
If there is a power cut, or if you press 1 or SET UP MENU while
Auto Channel Set is in progress, Auto Channel Set will be
interrupted; be sure to turn off the unit power once and try again
from step
A.
DO NOT press any button on the unit or Remote while Auto
Channel Set is in progress.
AUTO CHANNEL SET
SCANNING...
PRESS (MENU) TO END
ATTENTION
If you perform Auto Channel Set successfully during
installation, there's no need to separately perform the
Language Select, Clock Set or Channel Set procedures, but if
adjustments become necessary, they can be performed as
follows:
● Language setting ੬
pg. 20
● Tuner setting ੬
pg. 26
● Clock setting ੬
pg. 24
XVC33UM_01.book Page 17 Monday, August 4, 2003 7:24 PM