Jenn-Air 720-0150-LP - Manual (Page 12)

If the flames have yellow tips, loosen the locking
nut and move the bolt in a clockwise direction.
WARNING
Burner adjustments should only be performed
after the burners have cooled.
Always tighten the locking nut before relighting
the burner.
Locking Nut
If the flames are making excessive noise or
lifting, loosen the locking nut and turn the bolt in
a counter-clockwise direction.
Remember to tighten the locking nut before
relighting the burner. If you have any questions
regarding flame stability, please contact
customer service at 1-800-554-5799.
Adjustment Bolt
1. Specified clearance maintained 24 in. from
combustible materials/construction.
2. All internal packaging has been removed.
3. The hose and regulator are properly
connected.
INSTALLER FINAL CHECK
4. The unit has been tested and is free of leaks.
5. The gas supply shut off valve has been
located.
6. All burners are factory installed.
WARNING
1. Do not store spare LP gas cylinders under or near this appliance.
2. Never fill the cylinder beyond 80 percent capacity.
3. If the information above is not followed exactly, a fire resulting in death or serious injury could occur.
10