Jwin JX-CD530 - Manual (Page 7)

E.6
CLEANING THE CABINET
Wipe with a soft cloth. If the cabinet is very dirty, dampen (not dripping wet) the
cloth with a weak solution of soap water, and then wipe clean.
HANDLING COMPACT DISCS
1. This unit is designed to play compact discs bearing the identifica-
tion logo to the right. Discs that do not carry this logo may not
conform to the CD standard and may not play properly.
2. Dirty, scratched or warped discs may cause skipping or noise. Pay
attention to the following: Handle the disc only by the edges. To
keep the disc clean, do not touch the surface of the disc.
3. Discs should be returned to their cases after use to avoid serious
scratches that could cause the laser pickup to skip.
4. Do not expose discs to direct sunlight, high humidity, or high temperatures for
extended periods. Prolonged exposure to high temperatures can warp the disc.
5. Do not stick or write anything on either side of the compact disc. Sharp writing
instruments, or the inks used in some felt-tip pens, may damage the surfaces of
the disc.
6. Always place the compact disc to be played in the CD compartment with the
label facing upward. CD can be played on only one side.
CLEANING DISCS
1. Fingerprints should be wiped from the surface of the disc
with a soft cloth. Unlike conventional records, compact discs
have no grooves to collect dust and microscopic debris, so
gently wiping them with cloth should remove most of the
particles. Wipe in a straight motion from the inside to the
outside of the disc.
2. Never use such chemicals as record cleaning sprays, anti-
static sprays, benzene or thinner to clean compact disc.
Such chemicals can damage the plastic of the disc.
• The unit will not play a disc that has been inserted upside down, or discs that do
not conform to the Compact Disc standard. Also, the unit might not play discs
that are scratched, soiled or carry fingerprints.
• Both 8cm and 12cm discs can be played in this unit.
TECHNICAL SPECIFICATIONS
CD PLAYER SECTION
Frequency response ...................... 20Hz-20KHz
Wow and flutter ............................ below measure limits
Sampling frequency ...................... 44.1KHz
D/A converter ............................... 1-bit
Error correction method .............. CIRC
Pick-up ........................................... optical 3-beam semiconductor laser
(780 nM wavelength)
GENERAL
Power supply DC .......................... 3V using two “AA” batteries
AC/DC adaptor 220V - 4.5V
Dimensions ...................................... 138mm(W)x138mm(D)x29.5mm(H)
Weight ............................................ 212 grams
COMPACT
DIGITAL AUDIO