Jensen BT250 - Manual (Page 12)

Bluetooth Car Kit User Manual
8
Disconnect /
voice
recognition
Press to disconnect a call. Press and hold for two seconds to
activate the Voice Recognition function. After the tone, repeat
your pre-recorded voice tag: the number automatically dials.
Press to reject an incoming call. *Phone MUST Support voice
recognition.
LED indicator
Lights after pairing and during calls. Indicates power is on.
Pairing phones
To use a phone with the BT250 you must first pair the phone and the
BT250. Pairing is the process of linking the two products together.
1. DO NOT attempt to pair a phone while driving. Park your car
and with the ignition on proceed.
2. Press and hold the Answer/redial and Volume-Down buttons at
the same time until you hear a tone and the LED begins to flash.
If the light is already flashing attempt to pair.
3. Be sure Bluetooth is enabled on your phone. Follow the
documentation provided with your phone to search for new
devices.
4. Select the BT250 from the list of Bluetooth devices on your
phone.
5. Enter the passcode: 1234.
6. The LED will stop flashing when the phone is paired.
Note: You may follow the above steps to pair a second, third and
fourth phone. Pairing a fifth phone will cause the first pairing to be
deleted.