Jwin JT-P870 - Manual (Page 5)

12/19/2003 8:34 AM 5
INSTALLATION
Easy Set Up
1. Use the coiled cord to connect the receiver to the phone base or console.
2. Use the flat cord to connect the phone base to the wall jack.
3. Insert the 9V DC Adapter in the topside of the phone base and connect the opposite end to
an electrical outlet. The telephone will run a memory check for 15 seconds. The long tone
indicates that the memory check is complete.
4. Open the battery cover (on the bottom of the phone base) and install 4 “AA” batteries (not
included).
Note: Without batteries and adaptor for the power supply, the speakerphone and caller ID
function will not function. (The LCD will appear blank.) However, the dial-out and dial-in
function will continue to operate.
SETTINGS
After installing the batteries, you will be prompted to enter settings for Language, Area Code,
Time/Date, and LCD Contrast. At other times, you can enter settings mode by pressing the
[DEL] and [DOWN] keys at the same time.
Language Setting (English / French / Spanish)
1. After installing the batteries, the telephone will prompt you to select the language with
“ENGLISH” displaying on the LCD.
‚ Use the [UP] and [DOWN] buttons to select the appropriate language:
‚ E = English,
‚ F = French,
‚ S = Spanish)
2. Press [DEL] to confirm.
Area Code Setting
After the Language Setting you will be prompted to enter the area code setting:
1. Press the [UP] and [DOWN] buttons to set the first digit of the area code.
2. Press [DEL] to confirm the first digit.
3. Repeat first two steps to set the second and the third numbers.
Time/Date Setting
After the Area Code Setting, you will be prompted to enter the Time/Date Setting. At other
times if you need to set the time and date, depress the [TIME] button for 2 seconds to start the
time setting procedure, then:
1. The telephone will display the message: ‘Set Day’
2. Use the [OGM] or [MEMO/REPEAT] buttons to make your selection.
3. Press [TIME] to confirm.