JVC CA-FSB70 - Manual (Page 46)

7
English
AM antenna
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Connecting Speakers
To connect speakers
You can connect the speakers using the speaker cords.
1 If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2 Hold the clamp of the speaker terminal.
3 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: ª to ª and
· to ·.
4 Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one
speaker terminal.
RIGHT LEFT
SPEAKER
IMPEDANCE
6~16
Ω
SPEAKERS
1
2 3,4
ANTENNA
2
1
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
Speaker
cord Speaker
cord
Right speaker Left speaker
06_08FS_B70[C].p65 03.3.19, 10:49 AM 7