Jet Tools DC-1100G - Manual (Page 7)

7
Unpacking
DC-1100A/RC Dust Collector
1. Remove all contents from the shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material until after
the dust collector has been assembled and is
running properly.
Contents of the Shipping Carton
1 – Upper Bag Hanger
1 – Base
1 – Housing
1 – Hanger Bracket
1 – Owner's Manual
1 – Hose
1 – Warranty Card
1 – Motor/Fan Assembly
1 – Collector Bag
1 – Filter Bag
2 – Hose Clamps
1 – Retainer Strap
4 – Casters
1 – Inlet Port & Inlet Cap
3 – Support Legs
1 – Bag of Assembly Hardware
(16) M8 x 16 Hex Cap Screws
(22) M8 Flat Washers
0 (8) M6 x 12 Pan Head Flange Screws
0 (6) M8 Hex Nuts
Tools Required for Assembly
2 – 13mm Wrenches or Sockets
1 – 14mm Wrench or Socket
1 – #2 Cross Point Screw Driver
1 – 17mm Wrench
Bag of Assembly Hardware
Read and understand the entire contents of this manual before attempting set-up or
operation! Failure to comply may cause serious injury.