JVC AV 34WP84 - Manual (Page 29)

Initial Setup
29
Auto Tuner Setup
The auto tuner setup function is described on page 21 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M ENU button
π† To AUTO TUNER SETUP
è To operate
è To choose CABLE or AIR
Press the O K button to start
AUTO TUNER SETUP
CABLE
PRESS TO START
SELECT OPERATE EXIT MENU
TUNER MODE
OK
Programming will take approximately 1 to 2 minutes. The auto tuner is finished when the
message PROGRAMMING OVER! appears onscreen.
Channel Summary
Channel summary allows you to customize the line-up of channels received by your TV. You
can add or delete channels from the line-up or prevent any unauthorized viewers from watching
any or all 181 channels.
Press the M ENU button
π† To CHANNEL SUMMARY
è To operate
The Channel summary screen will now be displayed with
the channels set to scan marked with an “√”. You can delete
channels from the scan by removing the “√”. If any channels
were missed during auto tuner setup and you wish to add
them, you may by placing an “√” next to the channel number.
π † √® To the SCAN column
Press the O K button to include or delete from scan
Press the M ENU button when finished
You can block access to a channel by activating the channel lock.
Press the M ENU button
π† To CHANNEL SUMMARY
è To operate
π † √® To the Lock Column ( )
Press the Z ERO button to lock or unlock that channel
Press the M ENU button when finished
CHANNEL SUMMARY
06
07
08
09
10
CHNO.
SELECT OPERATE EXIT MENU
01
02
03
04
05
OK
SCAN CHNO. SCAN
Press the Menu button when finished
AV-34WP84 English 29 8/5/03, 8:56:58 AM