JVC RX-772VBK User Manual

Page 30

Advertising

Page 27

Preparing for Dolby Surround

The receiver memorizes two sets of Dolby Surround adjustments; one for Pro Logic and the other for 3ch
Logic.

On the front panel:

1. Press SURROUND MODE so that the Control

% / fi

fi buttons work for selecting the surround

modes.
The lamp next to the button lights up.

2. Press Control

% / fi

fi until “PROLOGIC” or “3CHLOGIC” whichever you want appears on the

display.
The PRO LOGIC or 3CH LOGIC indicator (as well as the SURROUND indicator) also lights up.
Each time you press the button, the surround modes change as follows (the indicator of the selected
surround mode also lights up on the display):

PROLOGIC:

Select this mode to watch a video source with Dolby Surround when you have
connected the rear speakers (and a center speaker).

3CHLOGIC:

Select this mode to watch a video source with Dolby Surround when you have
connected a center speaker and no rear speakers.

HALL:

This is JVC’s original surround mode, and is different from Dolby Surround. To
use this, see page 24.

SURR OFF:

No surround mode is applied.

3. Press SURROUND ADJUST so that the Control

% / fi

fi / @

@ / #

# buttons work for adjusting the

selected surround mode.
The lamp next to the button lights up.

4. Press Control

% / fi

fi until “CNT MODE” (Center Mode) appears on the display.

5. Press Control

@ / #

# to select the center mode.

Each time you press the button, the center modes change as follows:

WIDE:

Select this mode when the center speaker can reproduce the bass better than the
front speakers. All signals of the center channel are output through the center
speaker.

NORMAL:

Select this mode when the center speaker cannot reproduce the bass better than the
front speakers. The bass portions of the center channel signals are output through
the front speakers.

PHANTOM:

Select this mode when you do not use a center speaker. The center speaker channel
signals are output through the front speakers.

OFF:

Select this mode to turn off the center speaker channel.

Notes:
• If you have already set the center speaker size following the procedure described on page 16, you do

not have to select the center mode in this procedure.

• When you have selected “3CHLOGIC,” you cannot select “PHANTOM.”