Symbols on the machine, Symbols in the operator’s manual, Key t o symbols – Jonsered CS 2135T User Manual

Page 2: Symbols on the mac hine, Symbols in the operator’ s manual

Advertising
background image

2

English

KEY

T

O SYMBOLS

Symbols on the mac

hine:

W

ARNING! Chain saws can be

dangerous! Careless or improper use can
result in serious or fatal injury to the
operator or others.

Please read the operator’s manual
carefully and make sure you understand
the instructions before using the machine.

Always wear:

Approved protective helmet

Approved hearing protection

Protective goggles or a visor

Both of the operator

s hands must be used to

operate the chain saw.

Ne

ver operate a chain saw holding it with one

hand only.

Ne

ver let the guide bar tip come in contact

with any object.

WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.

Other symbols/decals on the mac

hine refer to special

certification requirements for certain markets.

Symbols in the operator’

s manual:

Switch off the engine b

y moving the stop

switch to the STOP position before carrying
out any checks or maintenance.

W

orking position

Chok

e

Alw

ays wear approved protective gloves.

Regular cleaning is required.

Visual chec

k.

Protectiv

e goggles or a visor must be worn.

Refuelling.

Filing with oil and adjusting oil fl

ow.

The chain br

ake must be engaged when the

chain saw is started.

WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.

You will find the following labels on your chain saw:

EP

A II

The Emissions Compliance P

eriod referred to on the

Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.

Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.

Advertising