John Deere ET-3303-J - Manual (Page 6)

6 3 1/4-Inch Belt Sander Operator's Manual
DON'T OVERREACH
Keep proper footing and balance at all times.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for better and safer performance. Follow instructions for
lubricating and changing accessories. Inspect tool cords periodically and replace if
damaged, have repaired by authorized service facility. Inspect extension cords
periodically and replace if damaged. Keep handles dry, clean, and free from oil and
grease.
DISCONNECT TOOLS
When not in use, before servicing, and when changing accessories, such as blades,
bits, cutters.
AVOID UNINTENTIONAL STARTING
Don't carry plugged-in tool with finger on switch. Be sure switch is off when plugged
in.
SECURELY MOUNT ACCESSORIES AND BLADES TO THE TOOL MAIN BODY
Extra care must be taken when using tools on elevated location (such as a roof
ladder, scaffold, or the like) to prevent injury to someone on a lower level in the event
the tool and/or accessory should drop.
NEVER TOUCH THE MOVING PARTS
Never touch the moving parts such as blades, bits, cutters and others.
WARNING
CAUTION
DON'T FORCE TOOL
It will do the job better and safer at the rate from which it was intended.
USE RIGHT TOOL
Don't force small tool or attachment to do the job of a heavy-duty tool. Don't use tool for
purpose not intended - for example - don't use circular saw for cutting tree limbs or logs.
DON'T ABUSE CORD
Never carry tool by cord or yank it to disconnect from receptacles. Keep cord from heat,
oil and sharp edges.
REMOVE ADJUSTING KEYS AND WRENCHES
Form habit of checking to see that keys and adjusting wrenches are removed from tool
before turning it on.