JVC RM-HP250DE - Manual (Page 17)

7
● If it is required to extent the cable, use the KA-280
extension connector.
● The total cable length should not exceed 100 meters.
NOTE
8 [HD/SD SDI OUTPUT] SDI signal output
connectors (RM-HP250AU)
These are output connectors for HD/SD SDI signals. Use
these to equipment with SDI input connectors (e.g., SDI
switcher, monitor or VTR).
The specification varies depending on the model.
RM-HP250AU : 3 outputs
8 [HD/SD SDI INPUT/OUTPUT] SDI signal input
and output connectors (RM-HP250DE)
These are HD/SD SDI signal input/output connectors. SDI
signal that is input will be output from the [HD/SD SDI
OUTPUT] connectors.
The specification varies depending on the model.
RM-HP250DE : 1 input, 2 outputs
9 [REMOTE] Connection connector of Remote
Control Panel
This connector connects to the remote control panel and
controls the camera.
When connected, remote control panel operations will take
priority over operations from RM-HP250 (3: FILE, 4:
PROCESS, 5: OPERATION).
Introduction
Transferred signals cannot be output via the camera
cable from the HD/SD SDI output connector on RM-
HP250DE. Signals will be output in the same format as
the input signals to HD/SD SDI input connector.
NOTE
0 [CAMERA CABLE] connector (26-pin)
Connect the optionally available camera cables to the
camera.
The VC-P110 series camera cables that can be used to con-
nect a camera to the RM-HP250 are available in four lengths
as listed below.
VC-P110 : 5 meters
VC-P112 : 20 meters
VC-P113 : 50 meters
VC-P114 : 100 meters
A menu setup is required according to the cables in use.
REF. : “Camera Cable Length Setup” on page 12.
Camera Cable (Optional)