JVC RM-HP250DE - Manual (Page 16)

6
1 [AC ` IN] connector
Connect this socket to a commercial power supply outlet
using the power cord provided.
2 [TALLY] terminals
These terminals input the tally control signals.
REF. : “Tally ” on page 14.
3 [INTERCOM] terminals
These terminals input and output the intercom signals.
In a system composed of multiple cameras and remote
control units, the intercom function provides intercommu-
nication between operators.
REF. : “Intercom” on page 14.
4 [AUX VIDEO INPUT] connectors
These connectors are used to input the return video sig-
nal, which returns the SEG (Special Effects Generator) or
switcher output signal to the camera viewfinder.
These two connectors are loop-through connected inside
to enable a bridge connection.
They are terminated automatically when they are not
bridge-connected.
Input VBS or HD component Y signal.
Introduction
Controls, Connectors and Indicators (continued)
Ⅵ Rear panel
5 [GENLOCK INPUT] synchronous signal input
connectors
These connectors are for reference sync signal input.
These two connectors are loop-through connected inside
to enable a bridge connection.
They are terminated automatically when they are not
bridge-connected.
Input BB or Tri-level sync signal.
6 [Y/G, P B /B, P R /R] component video signal
output connectors
The settings of the output signals from these connectors
can be switched between Y/P
B /P R , G/B/R using the SIG
SELECT switch on the connected camera or by using the
menu setup of the camera.
7 [COMPOSITE VIDEO] signal output connector
This connector outputs VBS (composite video) signal.
RM-HP250AU Rear Panel
RM-HP250DE Rear Panel
REMOTE HD/SD SDI
Y/G P B /B P R /R
INPUT OUTPUT
AC ` IN 230V ` 50Hz
TALLY
PGM PVW C
INTERCOM
AUX VIDEO INPUT GENLOCK INPUT
VIDEO OUTPUT
H C G
COMPOSITE VIDEO
CAMERA CABLE
REMOTE HD/SD SDI
OUTPUT
Y/G P B /B P R /R
AC ` IN AC120V 60Hz
TALLY
PGM PVW C
INTERCOM
AUX VIDEO INPUT GENLOCK INPUT
VIDEO OUTPUT
H
RTS
C G
COMPOSITE VIDEO
CAMERA CABLE
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0