JVC 0302MNV*ID*JVE - Manual (Page 30)

Filename [HRS5950EU3-EN.fm]
Masterpage:Left
30
EN
Page 30 December 4, 2001 5:14 pm
EDITING (cont.)
Output/Input Set L-1 OUTPUT Setting
The L-1 IN/OUT connector accepts only a composite signal
(regular video signal) and delivers either a composite signal
(regular video signal) or a Y/C signal (a signal in which the
luminance and chrominance signals are separated). Set “L-1
OUTPUT” to the appropriate mode depending on the type of
appliance connected to the recorder’s L-1 IN/OUT connector.
A
Access the Main Menu screen.
Press MENU.
B
Access the Output/Input Set screen.
C
Select the output or input mode for the L-1
IN/OUT connector.
D
Return to the normal screen.
Press MENU.
Press
rt
to move the
highlight bar (pointer) to
“OUTPUT/INPUT SET”, then
press OK or
e
.
Press
rt
to move the
highlight bar (pointer) to “L-1
OUTPUT”. Then, press OK
or
e
to select the appropriate
setting.
* The default setting is bold in
the table below.
8
L-1 OUTPUT
VIDEO : If a connected appliance’s input is
compatible only with regular video
signals, set to “VIDEO”.
S-VIDEO: If a connected appliance’s input is
compatible with Y/C signals, set to
“S-VIDEO”. You can obtain
high-quality S-VHS picture. (For
connection, be sure to use a 21-pin
SCART cable that is compatible with
the Y/C signal.)
HRS5950EU1-EN.book Page 30 Tuesday, December 4, 2001 5:32 PM