Janome MEMORY CRAFT 9500 - Manual (Page 44)

43
Sensor buttonhole
Select the pattern 17.
The buttonhole size is automatically set by placing a
button into the button holder in the rear of the
Automatic Buttonhole Foot R.
NOTE:
The button holder of the foot takes a button size of up
to 2.5 cm (1") in diameter.
Attach the Automatic Buttonhole Foot R.
To sew
Press the Up/Down Needle button to raise the needle.
Attach the Automatic Buttonhole Foot R snapping the
Pin into the Groove of the foot holder. Raise the
Presser Foot.
1 Pin
2 Groove
Pull the Button Holder to the rear, and place the button
in it. Push it tightly against the button.
3 Button Holder
NOTE:
If the button is extremely thick, make a test buttonhole
on an extra piece of the fabric. If it is difficult to fit the
button through the test buttonhole, you can lengthen
the buttonhole by pulling the Button Holder back a
little. The length of the buttonhole will be increased.
A Z
Square BH
13 14 15 16 17 18
19 20 21 22 23 24
R
SET
Adjust
Pull down BH Lever.
Sensor Auto
Auto 3
3
2
1
2
1
2
1