JVC TK-C205 - Manual (Page 6)

E-8
1 Power Supply cable
To input DC 12 V or AC 24 V power.
The AC 24 V power supply should
conform to the following:
U-type: Class 2 only
E-type: Isolated power supply only
2 Video signal output connector (BNC)
This BNC connector outputs a composite
video signal. Connect this to the video
input connector of a video monitor,
switcher, etc.
3 Safety cable
This wire is mounted to the ceiling slab
or channel. (Safety cable not included.)
4 Mounting holes
These holes are used to mount the
camera body to the ceiling. When using
a 4 inch square electrical box, the 2 holes
diagonally across are used to fix the box
in place.
(
੬ page 13)
5 Cable extraction hole
This hole is used to extract cables from
the side of the camera without opening
holes in the ceiling.
6 Cover
This cover is removed to pull the cables
through the
5 cable extraction hole.
Replace the cover after pulling the
cables.
7 Cover locking screw
This screw is removed when removing
the
6 cover.
Introduction
Names and Operations of Parts (continued)
3
2 1
4
5
6 7 7
4
Main unit side
Ⅲ Body Underside
CAUTION:
To avoid unforeseen accidents, attach the
safety cable. Otherwise, there is nothing
to prevent the camera from falling should
it come loose.
E-9
English
REC
PLAY FF REW REVERSE PAUSE/
STILL
REC
CHECK STOP/EJECT
COUNT/
CLOCK TIME
MODE TIMER
REC AL/PL
RESET MENU
VIDEO CASSETTE RECORDER
SHIFT/TRACKING SET/V.LOCK RESET
/CANCEL
OPERATE SR-L910E
OPE. LOCK
1
TO CAMERA TO CAMERA DATA I / O DATA I / O RX RX+ RX RX- TX TX+ TX TX- COM COM 1 2 3 4 5 6 7 8 COM COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 16/8 COM COM COM COM COM COM CAMERA CAMERA SW UNIT UNIT ALARM ALARM AUTO AUTO
4 3 1 2 8 7 5 6
2 3 4 5 6 7 8
1
MONITOR MONITOR OUTPUT OUTPUT MONITOR
SERIAL-2 SERIAL-2 SERIAL-1
VIDEO INPUT
VIDEO OUTPUT
OUTPUT OUTPUT 2
1 ON ON 2 3 4 5 6 7 8
POWER
OFF ON
AC INPUT
System diagram
Installation and connection
• Turn OFF the power supply to all equipment to be used before making connections.
• Read the Instruction Manual for each piece of equipment to be used before making
connections.
Camera 1
Video signal
Power
Camera 2
Video signal
Power
Camera 3
Video signal
Power
Camera 4
Video signal
Power
Power Unit
DC 12 V or AC 24 V
Switcher, etc. MONITOR
OUTPUT 1
MONITOR
OUTPUT 2
MONITOR
MONITOR
DVR, etc.
VIDEO IN
MEMO
Power supply necessary for one
TK-C205
DC 12V : 300mA
AC 24V : 280mA
• When the voltage drops due to fluctua-
tions in voltage or compatibility with the
power supply cable, the current in-
creases by 30% for each TK-C205.
VIDEO
INPUT