Jensen JCR-208 - Manual (Page 7)

6
OPERATING INSTRUCTIONS
SETTING THE CLOCK
When you connect the radio to an AC outlet for the first time the clock display
will begin flashing "12:00". The flashing will stop when you set the time.
1. Press and hold the TIME button and repeatedly press the HOUR button to
set the correct Hour.
2. Press and hold the TIME button and repeatedly press the MINUTE button to
set the correct Minute.
NOTE
There is a PM INDICATOR located in the top left-hand corner of the clock
display. Be sure to observe the PM indicator when setting the time to make sure
the time is set correctly for AM or PM. If the PM indicator is 'On', the time
displayed is "PM". If the PM indicator is 'Off, the time displayed is "AM ".
DIMMER OPERATION
Set the Dimmer to Hi for bright illumination and LO for the dark illumination.
LISTENING TO THE RADIO
1. Set the BAND SELECTOR to the desired band, AM or FM.
2. Slide the FUNCTION SELECTOR to the “ON” position.
3. Select your desired station with the TUNING CONTROL.
4. Adjust the VOLUME CONTROL to the desired listening level.
5. When you have finished listening, slide the FUNCTION SELECTOR to the
“OFF” position to turn the radio off.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change
the position of the unit until the internal antenna picks up the strongest
signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the position
and location of the antenna until you find the strongest signal.
AUTO INDICATOR
PM INDICATOR