JVC MINI DV & HDD & DVD SR-DVM700E - Manual (Page 31)

Masterpage:Right0
EN
31
Filename [DVM700EU_08DV Operation.fm]
Page 31Wednesday, 25 January 2006 10:28
BASIC OPERATIONS ON DV DECK
1
Load a cassette. Make sure the window side is up, the rear
label side is facing you and the arrow on the front of the
cassette is pointed toward the unit.
● Do not apply too much pressure when inserting.
● If the erase protection switch is set to ASAVEB, playback begins
automatically. It takes about 15 seconds until the playback
picture appears.
● The unit’s power comes on automatically.
2
Press DV/HDD/DVD on the unit repeatedly or DV on the remote
control so that the DV lamp lights up on the unit.
3
Find the programme start point. If the tape is advanced past the
start point, press
O. To go forward, press N.
4
Press I to start playback.
5
Press o to stop playback.
● To eject the cassette, press M (DV).
NOTES:
● When you record a tape on the DV deck with the recording speed
set to
ALPB, it is recommended to play back that tape back on this
DV deck. Digital video recorder from other manufacturers may not
be able to play back the tape properly.
● It is possible to play back on the DV deck and the HDD/DVD deck
simultaneously. However, either DVD or HDD can be played at
the same time.
Basic Playback
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
DV/HDD/DVD I
M o O N
DV
o
N O
I
DVD TV
DV lamp
Clean the video heads using a dry cleaning cassette
- M-DV12CL - when:
● No picture during playback.
● Block noise appears during playback.
● AUSE CLEANING CASSETTEB appears on the screen.
● AU01B lights on the front display panel.
NOTES:
● The heads get dirty in the following cases:
● in an environment prone to extreme temperature or humidity
● in a dusty environment
● flaw, dirt or mould on video tapes
● continuous usage for a long time
● AU01B will also light on the front display panel when you
attempt to play back a tape recorded with NTSC signals. This
unit cannot play back tapes recorded with NTSC signals.
Usable cassettes
● Cassettes marked P can be used with the DV deck.
● Tapes recorded in the DVCAM format can be played.
Accidental erasure prevention
To prevent accidental recording on a recorded cassette, set its
erase protection switch to
ASAVEB. To record on it later, set the
switch to ARECB.
Erase protection switch
DVM700EU_00.book Page 31 Wednesday, January 25, 2006 10:28 AM