JVC BC-D2300U - Manual (Page 8)

14
MENU SETTINGS
Menu contents (contd.)
[ ]: Factory Setting
Items
Colorimetry
Out Delay
Audio Group
Audio Delay
Profile Save
Profile Load
Color Bar
Settings
OFF
[ON]
[1FRAME]
1FRAME-90H
NO USE
[1]
2
3
4
–30
[0]
30
MEMORY 1
MEMORY 2
MEMORY 3
MEMORY 4
MEMORY 1
MEMORY 2
MEMORY 3
MEMORY 4
DEFAULT
[OFF]
ON
Contents
Turns the colorimetry parameter conversion function ON/OFF. This function
allows SD (ITU-R601) to be converted to HD (ITU-R709).
Normally, set to ON.
When this function is set to OFF, the normal display format changes. (
੬ p. 5)
Sets the delay time from the input to the output.
1FRAME
: Delays by 1 frame (33.37 ms).
1FRAME-90H : Delays by 1 frame -2.67 ms for 1080I. Delays by 1 frame
-2.00 ms for 720P.
Selects the audio signal group (groups 1 to 4) multiplexed on the SD digital serial
input signal.
If audio is not used, select No Use.
Sets the delay for the audio signal multiplexed on the SD digital serial input
signal.
Adjustment of ±30 (msec.) is possible with respect to the delay time set with
<Out Delay>.
Four independent memories are provided to store menu settings.
Selects the memory to be used to store the set menu contents.
* Items in the administration sub menu are not stored in memory.
Recalls menu setting stored in memory.
When set to DEFAULT, menu setting set before shipment is recalled.
When set to ON, the built-in color bar (7-line color bar) is output regardless of the
input.
The color bar output turns off automatically when you quit this menu.
…
…
15
[ ]: Factory Setting
Items
Administration
Remote ID
Remote Speed
Remote Port
Active Line
Alarm
Name
Version
Serial No.
License key
Running Time
Settings
[1]
31
9600
19200
[38400]
[REMOTE-IN]
ALARM
480
[486]
OFF
[ON]
[BC-D2300]
Contents
Press the [ENTER/MENU] button to enter the administration sub menu.
The following nine items can be set on the administration sub menu.
Sets the remote ID of this unit to remote-control this unit from the Host.
Sets the transmission speed (bit/s) of the remote control signal.
Selects the connection port for the host when this unit is remote-controlled.
REMOTE-IN : Connects RS-485 to the [REMOTE-IN] port.
Set to this position to remote-control this unit via the
[REMOTE-IN] connector.
ALARM : Connect the RS-232C to the [ALARM] port.
Set to this position to remote-control this unit via the [ALARM]
connector.
Sets the number of effective lines of the input signal when <Output> is set to
“1080I”.
With <Output> set to “720P”, the number is fixed at 480 lines (on the menu, --- is
shown).
When set to “OFF”, the output from the rear panel’s [ALARM] connector stops
(always open except when power is turned off).
Sets the device name that will be shown in the normal display.
For setting, refer to page 9.
Shows the firmware version of this unit.
Shows the serial number of this unit.
Sets the license key to enable optional features such as the variable enhancer
and color compensation function.
For setting, refer to page 9.
To obtain the license key, consult your JVC dealer.
Shows the approx. number of operating days of this unit.
Press the [ENTER/MENU] button twice to clear this number to 0.
Use this as a guide for determining when to replace the fan.
Menu contents (contd.)
…