Jensen PS475 - Manual (Page 6)

PS475
6
4 ohm nominal
2 ohm minimum
4 ohm nominal
2 ohm minimum 4 ohm nominal 4 ohm nominal 4 ohm nominal
L C
Inductor Capacitor
2 = 2 minimum
4 = 4 minimum
W W
W W
2 W 2 W
2 W 2 W
4W
4W
C
C
C
C
L
L
Wiring (continued)
Speaker Wiring
The Speaker Wiring diagrams illustrate options for connecting speakers and subwoofers.
Passive High and Low Pass Filter Chart
Frequency
Hz.
Speaker Impedance
2 Ohms 4 Ohms 8 Ohms
Inductor (L) Capacitor (C) Inductor (L) Capacitor (C) Inductor (L) Capacitor (C)
80 4.1mH 1000 µF 8.2mH 500µF 15mH 250µF
100 3.1mH 800 µF 6.2mH 400 µF 12mH 200 µF
130 2.4mH 600 µF 4.7mH 300 µF 10mH 150 µF
200 1.6mH 400 µF 3.3mH 200 µuF 6.8mH 100 µF
250 1.2mH 300 µF 2.4mH 150 µF 4.7mH 75 µF
400 0.8mH 200 µF 1.6mH 100 µF 3.3mH 50 µF
600 0.5mH 136 µF 1.0mH 68 µF 2.0mH 33 µF
800 0.41mH 100 µF 0.82mH 50 µF 1.6mH 26 µF
1000 0.31mH 78 µF 0.62mH 39 µF 1.2mH 20 µF
1200 0.25mH 66 µF 0.51mH 33 µF 1.0mH 16 µF
1800 0.16mH 44 µF 0.33mH 22 µF 0.68mH 10 µF
4000 0.08mH 22 µF 0.16mH 10 µF 0.33mH 5 µF
Four Speakers
Cuatro Altavoces
Quatre Haut-Parleurs
Two Speakers & Bridged Subwoofer
Dos Altavoces & Subwoofer en Puente
Deux Haut-Parleurs & Subwoofer en Pont
Two Subwoofers / Bridged Stereo
Dos Subwoofers / Stereo en Puente
Deux Subwoofers / Stereo en Pont
Four Speakers and Two Subwoofers
Cuatro Altavoces y Dos Subwoofers
Quatre Haut-Parleurs et Deux Subwoofers
Important: When running a subwoofer and two full-range
speakers together (Trimode operation), high and low
pass “passive crossover” filters must be used. Failure to
install these filters may damage your amp and/or
speakers.
Nota: Cuando use juntos un contrabajo y dos
altoparlantes de gama completa (operacion trimodal), se
deben usar filtros de alto y bajo paso. Si no instala estos
filtros puede causar dano a su amplificador o a sus
altoparlantes.
Note: Lors de lfutilisation simultanee dfun hautparleur
tres basses frequences et deux hautparleurs ordinaires
(appele fonctionnement trimodal ou a trois voies), vous
devez utiliser des filtres separateurs passe-bas et passe-
haut. Sans ces filtres separateurs, vous risquez
dfendommager votre amplificateur ou vos haut-parleurs.
4-Channel Mode 3-Channel Mode 2-Channel Mode