Getting started, Supplied accessories, Putting the batteries into the remote control – JVC CA-HXZ3R User Manual

Page 9: Connecting antennas

Advertising
background image

– 6 –

Getting Started

Supplied Accessories

Make sure that you have all the following items.
The number in the parentheses indicates the quantity of the
pieces supplied.

• AM (MW/LW) loop antenna (1)
• FM antenna (1)
• Remote control (1)
• Batteries (2)

If anything is missing, consult your dealer immediately.

Putting the Batteries into the Remote Control

Insert the batteries—R6(SUM-3)/AA(15F)—into the remote
control, by matching the polarity (+ and –) on the batteries
with the + and – markings on the battery compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.

Connecting Antennas

FM antenna

1

Attach the FM antenna to the FM 75

COAXIAL terminal.

2

Extend the FM antenna.

3

Fasten it up in the position which gives you
the best reception, then fix it on the wall, etc.

About the supplied FM antenna

The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.

To connect an outdoor FM antenna

Before connecting it, disconnect the supplied FM antenna.

Outdoor FM antenna
(not supplied)

A 75

Ω antenna with coaxial type connector

(DIN 45325) should be used.

1

3

R6(SUM-3)/AA(15F)

• DO NOT use an old battery together with a new

one.

• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery

compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, it will be damaged from battery
leakage.

FM antenna (supplied)

FM 75

COAXIAL

LOOP

AM EXT

ANTENNA

FM 75

COAXIAL

LOOP

AM EXT

ANTENNA

Continued

2

EN01-08.CA-HXZ3R[B]f.p65

5/21/02, 2:10 PM

6

Advertising