JobSite Systems LST-RLS - Manual (Page 8)

REMOVAL OF GRILLE
Removing the Grille
If the grille is already installed, remove it by
using a bent paper clip or the tip of a
corkscrew and pulling it away from the
frame. See Figure 4.
PAINTING THE GRILLE
AND FRAME
Painting the Speaker Frame
The speakers must be removed prior to
painting the frames.
Painting the Grilles:
The grilles should be painted before they
are installed on the speakers. The best
results will be obtained by using a spray
gun or airless sprayer. Thin the paint, and
then apply several light coats. This
technique helps prevent clogging of grille
holes. Paint both sides of the grille to cover
all the white paint.
OPERATION
Listening at Higher Volumes:
Listening at Higher Volumes:
It requires more power to achieve a
reasonable volume of sound in a large room
than it does in a small room. It is possible to
turn the volume so high that the amplifier
runs out of power. This creates “clipping”
distortion.
Clipping distortion makes treble sound
very harsh and unmusical. When you hear
harsh sounding treble from any good
speaker, turn the volume down
immediately! You are much less likely to
damage a speaker with a large amplifier
less likely to produce any clipping distortion.
6
Figure 4
DS00388ACN-LST_RLS-CTR.qxp 11/18/04 9:15 PM Page 6