John Lewis JLWD 1610 - Manual (Page 11)

• Selection of drying time in minutes.
After starting the programme, the
remaining time is updated every minute.
If you select a drying time longer than
55 minutes, after a few seconds, the
display will show it in hours and
minutes.
• Delay start, a time value indicated in
hours and selected by the relevant button.
The delay time (20 hours max) is
displayed for a few seconds, then the
duration of the selected programme
reappears. After you have pressed the
button 8, the countdown is updated every
hour, and, for the last hour, every minute.
• An incorrect option selection has
been made: this is indicated by the
message Err for a few seconds when an
option incompatible with the current
programme is selected.
• An alarm code indicates a fault with the
machine (see the relevant chapter).
First use
• Ensure that the electrical and
water connections comply with
the installation instructions.
• Remove the polystyrene block and
any material from the drum.
• Before the first wash, run a cotton
cycle at the highest temperature
without any laundry in the
machine, to remove any
manufacturing residue from the
drum and tub. Pour 1/2 a measure
of detergent into the main wash
compartment and start the
machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of a washing cycle
• if there is a fault
You can deactivate the acoustic signal
(except if there is a fault) by pressing the
buttons 5 and the 6 simultaneously for
about 5 seconds. By pressing these buttons
again the acoustic signal is reactivated.
11