JVC TK-C215V4U - Manual (Page 21)

21
After setting is complete, mount the Inner dome.
1. Mount the inner dome .
Mount the inner dome to the claws (3 locations).
CAUTION:
● Mount the inner dome such that it does not
cover the lens.
● When mounting the inner dome, be careful
not to move the lens position. The image
angle set previously will go out of
alignment.
After setting is complete, mount the dome cover.
1. Mount the dome cover.
Align the position marks on the camera unit
and dome cover, followed by pressing in
directly to mount the cover.
CAUTION:
Press the dome over until a “click” sound is
heard. Check that the cover is firmly mounted.
Failure to mount the cover firmly may cause
this cover to fall off.
As a general characteristic unique to CCDs,
white-spots may appear on the screen with age.
In order to reduce this phenomenon, this unit is
equipped with a white-spot correction feature.
Switch on the camera power supply and wait for
at least 30 minutes.
1. Remove the dome cover.
2. Cover the lens surface using a black sheet
of paper, etc. so that light does not enter
the lens.
3. Set the function selection switch 8 to
[SPOT]. (
A pg. 11)
4. Press and hold the SPOT CORRECTION
button for more than 2 seconds.
● White-spot correction will start. Correction
may take several seconds for completion.
NOTE:
● Maximum correction: 32
● The white-spot correction feature of this
unit does not guarantee the correction of
all white spots.
Depending on the characteristic of white
spots, correction may not be possible.
● When performing white-spot correction,
accurate data may not be achieved in case
of highly detailed pixels since correction is
made using the information of surrounding
pixels.
● The result of white-spot correction is
maintained until the next correction is
performed.
Mounting the Inner Dome
Mounting the Dome Cover
Claws (3 locations)
Inner Dome
1.
Position mark
White-spot correction
RESET/[SPOT]
LL PHASE
1
O
N
2
3
4
5
6
7
2
4
WHT.
BAL.
8
B
R
Function selection switch 8
[SPOT] button
TK-C215V4_EN.book Page 21 Wednesday, June 14, 2006 8:00 PM