JAI CV-M50IR - Manual (Page 6)

- 5 -
CV-M50IR
Pin no. Signal Remarks
1 NC
2 EEN output * Note
3 GND
4 NC
5 Ext. Trig input * Note
6 WEN output * Note
Pin no. Signal Remarks
1 GND
2 +12 V DC input
3 GND
4 Video output Parallel with the BNC video output. Avoid double termination.
5 GND
6 HD input/output HD in as factory setting. *1)
7 VD input/output VD in as factory setting. *1) *2)
8 GND
9 NC NC as factory setting. Pixel clock output. *1)
10 GND
11 +12 V DC input
12 GND
5. Pin Assignment
5.1. 12-pin Multi-connector (DC-IN/SYNC.)
Type: HR10A-10R-12PB-01 (Hirose) male
Seen from rear.
Notes:
*1) Signals on pin no. 6, 7 and 9 can be changed by jumper setting.
See “7.3. Jumper Settings” for more information.
*2) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
5.2. 6-pin Multi-connector (TRIGGER)
Type: HR10A-7R-6PB (Hirose) male
Seen from rear.
* Notes:
The functions available on the 6-pin multi-connector are not effective in
long time exposure mode.