JVC CA-HXZ9V - Manual (Page 23)

– 18 –
English
4
Select a track from the selected
disc in step
3 .
On the unit:
Turn
4 / ¢ to select the
track number, then press
SET/DISPLAY.
On the remote control:
Press the number buttons.
• For how to use the number
buttons, see “To go to another
track directly using the number
buttons” on page 17.
5
Program other tracks you want.
• To program tracks from the same disc, repeat step 4.
• To program tracks from a different disc, repeat steps 3
and 4.
6
Press CD
3¥8 SELECT.
The tracks are played in the order you
have programed.
• If the playing disc is an MP3 disc, the
MP3 indicator lights up.
To stop playing, press 7.
To exit from Program Play mode, press CD PLAY MODE
repeatedly until the PRGM (program) indicator goes off (or press
PROGRAM on the remote control) after playback stops.
• If you try to program the 51st track, “CD FULL” will be flashing
on the display.
• If you have tried to program a track from an empty tray, “NO
DISC 1,” “NO DISC 2,” or “NO DISC 3” will appear on the
display for 2 seconds.
• If the track number you have programed does not exist on the
disc, it will be skipped during play.
Track number
CD3
CD2
CD1
P R G M
Disc number Program step number
SET /
DISPLAY
VC D NUMBER
PRESET
1
4
7
10
2
5
8
3
6
9
10
SELECT
Programming the Playing Order of the Tracks
—Program Play
You can arrange the playing order of the tracks before you
start playing. You can program up to 50 tracks.
• To use Repeat Play (see page 20) for Program Play, press
REPEAT after starting Program Play. Only REPEAT 1 and
REPEAT ALL can be selected for Program Play.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 2 again.
1
Load discs.
• If the current playing source is not the CD player, press
CD 3¥8 SELECT, then 7 before going to the next step.
2
Activate the Program Play mode.
On the unit:
Press CD PLAY MODE repeatedly
until “CD PROGRAM” appears on
the display.
• Each time you press the button, the play
mode changes as follows:
On the remote control:
Press PROGRAM so that
“CD PROGRAM” appears
on the display.
• The PRGM (program) indicator lights up on the display.
3
Press one of the disc number
(CD1, CD2, or CD3) buttons
to select the disc you want to
play.
CD PLAY
MODE
PROGRAM
CD PROGRAM
Canceled
(Continuous Play)
CD RANDOM
P R G M
Continued
EN14-25.CA-HXZ7/9V[US,UN,UX]/1 22/1/03, 4:50 PM 18