Jura Capresso IMPRESSA F5 - Manual (Page 15)

15
As long as STEAM READY os on view in the display, the
machine is ready to dispense steam.
Ⅲ Fill the container with 2.5 dl of fresh water.
Dip the milk pipe into the container with the fresh water.
When READY appears in the display, press the steam prese-
lect key
(8) again to set the machine in readiness for the
steam function.
Ⅲ Open the tap for dispensing steam/hot water (14) (Fig. 13) in or-
der to draw steam.
Ⅲ Draw steam until the container with the fresh water is empty.
This procedure rinses the Easy-Auto-Cappuccino Frother (15)
and the milk pipe with fresh water.
Ⅲ Cleaning of the Easy-Auto-Cappuccino Frother (15) is now com-
plete, your IMPRESSA is ready for use.
14. Switching off the IMPRESSA
To ensure perfect operation, please switch your IMPRESSA
to standby mode with the
(3) symbol first. Then switch
the machine off with the power switch (21).
Ⅲ
READY
Ⅲ Switch off the IMPRESSA using the ON/OFF key
(3).
Ⅲ
RINSING
Ⅲ An automatic rinsing operation is started.
15. Programming
When your IMPRESSA leaves the factory it is adjusted such
that you can draw off coffee without having to change any
settings. However, you can programme various parameters
individually.
You can programme the following stages:
¼ Filter
¼ Water hardness
¼ Aroma
¼ Temperature
¼ Time
¼ Automatic switch-on time
¼ Automatic switch-off time
¼ Draw-offs
¼ Language
¼ Display
Programming key (4)
Use the programming key (4) to open or quit the
programming mode (no saving of values effected).
Rotary switch
Turn the Rotary Switch to change the adjusted values or to
select the next programming step.
Press the Rotary Switch to check the values adjusted or to
save the values selected
15.1 Programming the filter
Refer to Chapter 5.1 «Inserting the filter».
15.2 Programming the water hardness
Refer to Chapter 4 «Adjusting the water hardness».
15.3 Programming the aroma ROBUST
or STANDARD
When the machine leaves the factory, the aroma is set to
robust. If requested it can also be set to Standard.
E