JVC LPT0923-001B - Manual (Page 78)

Filename [DR-MH30EU_10Subsidiary.fm]
Masterpage:Left+
78
EN
TROUBLESHOOTING
Page 78 Tuesday, 29 June 2004 17:40
Recording (DVD Deck)
● The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( ੬ pg. 70)
● No disc or a disc not being compatible with the unit is loaded.
]Load a recordable disc on the unit. (੬ pg. 5)
● The disc loaded is not formatted.
]Format the disc. (੬ pg. 74)
● A finalised DVD-R disc is loaded.
]Recording cannot be made on finalised discs. Load a recordable
disc on the unit.
● The disc is full or does not have enough space for the title to be
recorded.
]Clear unnecessary titles on the disc or load a blank disc.
( ੬ pg. 51)
● The DVD-RAM disc loaded has had its protect tab slid to the
protect position.
]Release the protect tab. (੬ pg. 8)
Recording (HDD Deck)
● “L-1”, “L-2” or “F-1” has been selected as the input mode.
]Set to the desired channel.
● The camcorder has not been properly connected.
]Confirm that the camcorder is properly connected.
● The input mode is not correct.
]Set the input mode to “F-1”. (੬ pg. 59)
Timer Recording
● Date and time is not correct.
]Set date and time correctly. (੬ pg. 73)
● Timer recording is in progress.
]Timer programming can’t be performed while a timer recording
is in progress. Wait until it finishes.
● Date and time is not correct.
]Set date and time correctly. (੬ pg. 73)
● Date and time set on the unit is not correct.
]Set date and time correctly. (੬ pg. 73)
● The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( ੬ pg. 70)
● The unit’s channel positions have been set incorrectly.
]Refer to “ShowViewTM System Setup” (੬ pg. 70) and re-
perform the procedure.
● The satellite receiver is not connected properly to this unit.
]Connect the satellite receiver to the L-2 IN/DECODER
connector properly. ( ੬ pg. 48)
● Power failure occurred.
]Set date and time correctly. (੬ pg. 73)
● 32 programmes have already been timer programmed.
]Clear unnecessary programmes on the unit, then try timer
programming again. ( ੬ pg. 47)
● The PC’s data recorded on a DVD-RAM drive cannot be cleared
on this unit.
]Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) ( ੬ pg. 9, 74)
The desired programme cannot be recorded.
Recording cannot be made.
TV broadcasts cannot be recorded.
Camcorder recording is not possible.
Timer programming cannot be made.
Timer programming recording does not start.
S HOW V IEW Timer Programming cannot be made.
The S HOW V IEW system does not timer-record properly.
Automatic Satellite Programme Recording does not start.
On the front display panel, “– –:– –” appears.
“PROGRAMME FULL” appears on the TV screen during timer
programming.
The disc space does not increase when recorded titles are
cleared.
DR-MH30EU_00.book Page 78 Tuesday, June 29, 2004 5:41 PM