Video channel set, Access video channel mode, Set video channel – JVC VIDEO PLUS HR-S6965EK User Manual

Page 47: Exit video channel set mode

Advertising
background image

advanced features

47

before you start

The power cord must be

plugged in and

connected to the VCR

The VCR must be turned

off and no cassette

inserted

The Remote Control

must have batteries

inserted

The TV set must be

turned on

Video Channel Set

The VCR can send picture signals to the TV set in one of two ways; RF
(ordinary cable included with this VCR) and AV (via a 21-pin SCART cable
available from TV and Hi-Fi dealers). Depending upon which method you
use, the VCR must have the correct method set up in order to work. The Auto
Setup procedure normally takes care of this but if for any reason this fails to
happen, the instructions below describe how to set the Video Channel
manually.

Access Video Channel Mode

Press and hold the S button for 5 seconds on
the VCR until the display panel shows the
following information:

Set Video Channel

for av connection

Press

PR

until the

display panel shows ‘CH--’ .
The Video Channel is now set to

OFF

.

Go to

Step 3

.

for rf connection

Press

PR

or

PR

to set

the VCR to a vacant channel number between 52
and 69 which is not occupied by any station in
your area (refer to station list on page 52). In the
example, we have presumed that channel 52 is
vacant and have set the VCR to 52:

Now tune the TV set to channel 52 (refer to TV manual if
necessary
); you should see two vertical white bars appear
on the TV screen. If the bars do not appear or are not
clear, choose another vacant channel pressing PR buttons
on the Remote Control and try again. If you cannot
obtain the vertical white bars on any channel between 52

and 69, consult your local JVC dealer.

Exit Video Channel Set Mode

Press

.

To view pictures from your VCR you must now set your TV to either the Video
Channel or to AV mode, depending upon your choice above.

S-VHS

VCR

S-VHS

VCR

S-VHS

VCR

HR-S6965EK-EN/p43-47

2/19/03, 07:56 PM

47

Advertising