JVC A-UXP38V - Manual (Page 26)

– 23 –
English
2
Set the on-time you want the
unit to turn on at.
1) Press
¢ NEXT or PREV 4 to set the
hour, then press TIMER.
2) Press
¢ NEXT or PREV 4 to set the
minute, then press TIMER.
The unit enters off-time setting mode.
3
Set the off-time you want
the unit to turn off (on
standby) at.
1) Press
¢ NEXT or PREV 4 to set the
hour, then press TIMER.
2) Press
¢ NEXT or PREV 4 to set the
minute, then press TIMER.
The unit enters source selecting mode.
4
Press
¢ NEXT or PREV
4 to select the timer mode
(Daily Timer or Recording Timer)
and the source to play, then press
TIMER.
• Each time you press
¢ NEXT or PREV 4,
the timer mode and the source change as
follows:
CD TAPE
TUNER TUNER DAILY REC
DAILY DAILY
DAILY TUNER : tunes into the last station you were listening
to. (Daily Timer)
REC TUNER : records the last station you were listening to.
(Recording Timer)
• Put a recordable cassette into the deck.
DAILY CD : plays a CD. (Daily Timer)
DAILY TAPE : plays a tape. (Daily Timer)
• Make sure that the tape direction is correct.
5
Press
¢ NEXT or PREV
4 to set the volume level.
• You can select the volume level
(“VOLUME 0” to “VOLUME 40” and “VOLUME –”). If
you select “VOLUME –,” the volume is set to the last
level when the unit has been turned off.
To turn off the volume while the Recording Timer
(
REC TUNER) is working, set the volume level
“VOLUME 0”.
Using the Timers
There are three timers available — Daily Timer, Recording
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit (see page 9). When you press TIMER on the unit for more
than 3 seconds, the display alternates between “ADJUST” and
“CLOCK” for about 5 seconds.
Using Daily Timer and Recording Timer
You can set the timer whether the unit is on or off.
When the on-time comes, the unit automatically turns on
(the
indicator flashes just before the on-time, and continues
flashing while the timer is operating.) Then, when the off-time
comes, the unit automatically turns off (on standby).
The timer setting remains in memory until you change it.
• When the DAILY indicator is lit on the display, the timer acts
as the Daily Timer. Once the Daily Timer has been set, it will
be activated at the same time everyday until the timer is turned
off.
• When the REC indicator is lit on the display, the timer acts as
the Recording Timer. After the Recording Timer has been
performed, the details of the setting remain stored but the
timer is turned off.
Before you start...
When using “ TUNER” as the source to play, make sure to
select the desired station before turning off the power.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 1 again.
On the unit ONLY:
1
Press and hold TIMER for more than
3 seconds.
The timer ( ) indicator lights up, and the timer
mode indicator (DAILY or REC) and the current
on-time flash on the display.
The unit enters on-time setting mode.
EN20-26.UX-P38[US,UB,UN] 31/07/2001, 10:25 am 23