JBL GTS100 - Manual (Page 29)

29
Specifications
Continuous Power Output 35 watts x 2
(20Hz – 20kHz, (4 Ohms, 0.05% THD)
14.4V Battery Voltage) 50 watts x 2
(2 Ohms, 0.08% THD)
100 Watts x 1
(4 Ohms, 0.08% THD)
Signal to Noise Ratio 100dBA
Frequency Response 10Hz – 50kHz (+0, – 1dB)
20Hz – 20kHz (+0, – 0.1dB)
Damping Factor >200
Slew Factor >5
Line Level Input Sensitivity 100mV – 4V RMS (500mV at center detent)
(for rated power)
Line Level Input Impedance 10k Ohms
Speaker Level Input Impedance 15 Ohms
Speaker Level Input Sensitivity 200mV – 8V RMS (1V at center detent)
Preamp Output Sensitivity 2V Out for 4V Speaker Level Input
Minimum Speaker Impedance
Single Ended, Non-Bridged 2 Ohms
Bridged 4 Ohms
Built-In Electronic Crossover 80Hz, 18dB per octave Low Pass Filter
Frequency and Slope 100Hz, 18dB per octave High Pass Filter
Power Requirement 11 to 16V DC Negative Ground
Fuse Size 20 Amp ATC Type Fuse
Size (L x W x H) 6 5 /
8
" x 9 1 /
4
" x 2"
(168.3mm x 235.0mm x 50.8mm)
Weight 4lbs. 3oz. (1.90kg)
Speaker Input / Output Mating Molex Mini-Fit Jr. # 39-01-2040
Connector Metal Pins: 39-00-0038
Power Mating Connector Plastic Housing: AMP #1-480700-0
Metal Pins for Ground & +12V: AMP # 350923-3
Metal Pins for Rem. In: AMP # 350536-1
JBL 1394 Manual 7/17/98 11:49 AM Page 29