Operating the vcr, Slide the remote control mode selector to vcr, Press and hold vcr – JVC TH-S66 User Manual
Page 18: Press enter, Release vcr
Operating external components with the remote control
15
7
To set the manufacturer’s code
You can operate a JVC VCR without setting the manufacturer’s
code.
1
Slide the remote control mode selector
to VCR.
2
Press and hold
VCR.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Panasonic VCR:
Press 2, then 1.
For a Philips VCR:
Press 0, then 5.
5
Release
VCR.
If there is more than one code listed for your brand, try each
one until you enter the correct one.
7
Operation
Aim the remote control at the VCR.
IMPORTANT
Before using the remote control to operate a VCR;
Set the remote control mode selector to VCR.
The following buttons are available:
VCR:
Turns VCR on and off.
3 (play button): Starts playback.
7 :
Stops operation.
8 :
Pauses playback.
y:
Fast forwards video tape.
1:
Rewinds video tape.
REC:
Press this button together with 3 (play button) to
start recording or together with 8 to pause
recording.
CHANNEL +/–: Changes the TV channels on the VCR.
Operating the VCR
Manufac-
turer
Code
Manufac-
turer
Code
JVC
01
Nokia
16
Aiwa
02, 20
Nordmende
17 – 19, 31
Bell+Howell 03, 16
Orion
20
Blaupunkt
04
Panasonic
21
CGM
03, 05, 16
Philips
05, 22
Daewoo
34
Phonola
05
Digtal
05
Saba
17 – 19, 23, 31
Fisher
03, 16
Samsung
24, 25
G.E.
06
Sanyo
03, 16
Grundig
07
Sharp
26, 27
Hitachi
08, 09
Siemens
07
Loewe
05, 10, 11
Sony
28 – 30, 35
Magnavox
04, 05
Telefunken
17 – 19, 31, 32
Mitsubishi
12 – 15
Toshiba
33
See page 14 for button locations.
TH-S66-S55[B].book Page 15 Friday, January 14, 2005 10:40 PM