Unpacking, Cleaning, Positioning – John Lewis JLFFW2005 User Manual

Page 7: Climate classification

Advertising
background image

7

Unpacking

The appliance must always be transported in the

upright position as indicated on the outside of the

packaging.
After each transportation the appliance must not be

switched on for approx. 2 hours. to ensure the coolant gases

settle.
Unpack the Fridge Freezer and check for any possible

damage. If the appliance is damaged please report this to the

John Lewis branch from which you purchased; in this case

please retain the packaging.

Cleaning

Remove all adhesive tape and ties, which ensure the internal

fittings do not move during transportation.
Wash the inside of the appliance using lukewarm water and

mild detergent; using a soft cloth.
Further cleaning advice is given on page 19.

Positioning

The appliance should be located in a well ventilated, dry

room.To ensure correct operation the appliance should:

Not be exposed to direct sunlight.
Not be installed next to radiators, cookers or other

sources of heat.
Only be installed in a location where the ambient

temperature corresponds to the climate classification for

which the appliance is designed.

Climate Classification

The climate classification can be found on the rating plate;

which is located on the bottom left hand side of the fridge

compartment, see page 5 .
The table shows the correct operating ambient temperature

for each climate class.

Class of climate

Ambient temperature

SN

+10…+32°C

N

+16…+32°C

ST

+18…+38°C

If the temperature rises above or falls below the stated
ambient temperature for the climate class, the operation of
the appliance may be affected.
Ventilation
You should ensure that air can circulate freely around the
back and top of the cabinet. In the Instruction manual bag
there are two spacers which must be fitted to the top rear
corners. This will ensure a gap is maintained between the
Fridge Freezer and the wall.
Loosen the screws and insert the spacer under the screw
head, then re-tighten the screws.

Levelling
When placing the appliance ensure that it stands level, to
prevent vibration, excessive noise and to ensure the
doors shut correctly.

Level the appliance by turning the 2 adjustable feet at the
front of the Fridge Freezer.

When placing the refrigerator keep minimal

distances recommended in figure.

A: placing it under a wall-cupboard
B: placing it freely

Advertising